Unable to setup NPVR with Hauppauge PVR-150

[ron7]

At the end of the long list of messages (No devices in the list), I was able to install the "HCW_MCMPEG2MUX.AX".
Then, in order to see the TV (connected via a composite cable), I need to setup the device (add a Cannel).
BUT, When I try to add a channel I get an Unhandled Exception from NextPVR: "Key Not Found"
The JIT provides a lot of information about where exactly the problem is in the code.

I attached a zip file with two text files:
NPVR.log
NextPVR error.txt that has the text message from JIT.

Please advise.

[johnsonx42]

The NPVR log doesn't show anything, other than the fact you don't have the current patches installed; please apply the patch archive from the thread in my sig.

Then if the problem still happens, post the log after you get the error. It's usually best to post all the logs, not just the NPVR.log.

[ron7]

I want to thank you for your support.
I have done everything listed on your sig.
I am sure something is missing.
How can I find what is missing?

Attached please find a new zip file with the current JIT error text, and a the complete log subdirectory.

[Reddwarf]

Are you sure you have a PVR-150? The PVR-150 is supposed to have a hardware encoder, but your NextPVR is looking for the software encoder filter, and when it doesn't find it, it disables analog support. Can you view the Devices screen and post the logs?

[sub]

I want to thank you for your support.
I have done everything listed on your sig.
I am sure something is missing.
How can I find what is missing?

Attached please find a new zip file with the current JIT error text, and a the complete log subdirectory.

This error seems to he happening when you try manually adding a channel. Its not clear to me exactly what it doesnt like. Can you post a screenshot of that screen immediately prior to clicking the ok button?

System.Collections.Generic.KeyNotFoundException: The given key was not present in the dictionary.
at System.ThrowHelper.ThrowKeyNotFoundException()
at System.Collections.Generic.Dictionary`2.get_Item(TKey key)
at NShared.AddAnalogChannelForm.buttonOK_Click(Object sender, EventArgs e)

[ron7]

I am sure I have the PVR-150MCE.
I have attached the error after I viewed the Device screen and tried to setup the device.
See the zip file in my previous post.
I have run the FilterCheck utilty and I attached the results here

Thank You

[johnsonx42]

I want to thank you for your support.
I have done everything listed on your sig.
I am sure something is missing.
How can I find what is missing?

I will leave sub to troubleshoot your error when attempting to add the channel.

However, you still don't appear to have the patch archive installed. Your logs are missing certain messages that were introduced with some of the patches.

[Reddwarf]

@Sub, why is it looking for the SW-encoder components when they are not needed? A bug?

[johnsonx42]

It's not looking for them, just reporting their presence or absence. his analog device setup is fine.

[Reddwarf]

It's not looking for them, just reporting their presence or absence. his analog device setup is fine.

Did you look at Nrecord.log? It seems to me that it is disabling analog support.