2011-03-06, 10:31 AM
(This post was last modified: 2011-03-06, 10:35 AM by Greek Wizard.)
Really struggling with this.
I have a HVR 2250 with 2 Motorola STBs.
I tried this on NPVR 1.5x and now 2.0.3
I have blastcfg setup and both work fine in testing (Port 1 for STB#1, port 2 for STB #2). Everything works perfect there.
NPVR is set up as STB #1 on composite and STB #2 on composite (this was the only way I could get them working properly), although I don;t think that would make a difference because I tried it with composite_2 and although I had no video, it still did not change.
I have a few channels different on each line up for testing, and all the ones that are the same, I have "merged" together, but regardless what I enter as a channel only Box #1 changes channels.
When recording, NPVR still does not change the channel on STB #2.
Both are setup to use the HaupBlast.exe {Channel} argument. I even tried copying the HaupBlast.exe and renaming it for device #2.
Thoughts? Some hidden setting somewhere I hope? Is it possible that nPVR does not support multiple blasters?
I have a HVR 2250 with 2 Motorola STBs.
I tried this on NPVR 1.5x and now 2.0.3
I have blastcfg setup and both work fine in testing (Port 1 for STB#1, port 2 for STB #2). Everything works perfect there.
NPVR is set up as STB #1 on composite and STB #2 on composite (this was the only way I could get them working properly), although I don;t think that would make a difference because I tried it with composite_2 and although I had no video, it still did not change.
I have a few channels different on each line up for testing, and all the ones that are the same, I have "merged" together, but regardless what I enter as a channel only Box #1 changes channels.
When recording, NPVR still does not change the channel on STB #2.
Both are setup to use the HaupBlast.exe {Channel} argument. I even tried copying the HaupBlast.exe and renaming it for device #2.
Thoughts? Some hidden setting somewhere I hope? Is it possible that nPVR does not support multiple blasters?