MVP Screen Position V.6

[Ron22]

I have a new version ready on wiki.
This version now will display a yellow box on the screen. You can move the box around using the Up,Down,Left Right buttons.The box then can be sized with the 2,8,4,6 buttons.
The setting for Width,Height, Offset X, Offset Y display on the screen. You will have to enter these number in the config part of the utillity.
The way I would sugest you go about this would be to set the X, Y offsets to 0. Then change the Width to 700 and height to 500.
Then you should be able to move the box around to where you want it.

[Pioneer4x4]

That is GREAT! I love things like this. That is a much eaiser way to set it up. Plus since my PC and TV are on different floors, it really helps.

FWIW, my settings are this now. I'm off to check it on the TV now.
<MVPWidth>624</MVPWidth>
<MVPHeight>440</MVPHeight>
<MVPOffsetX>32</MVPOffsetX>
<MVPOffsetY>20</MVPOffsetY>

I'd like to see what everyone elses settings are, especially NTSC. This in on a JVC 36" I'd like to see what TV's display the highest resolution, less overlap.

[mikeg22]

I'm confused how to use this. I used the plugin to get the 4 parameters, input them into the config program, hit ok...now what? I reset my MVP and it is still as off-center as it was before.

[Ron22]

I'm confused how to use this. I used the plugin to get the 4 parameters, input them into the config program, hit ok...now what? I reset my MVP and it is still as off-center as it was before.

I think the biggest problem with this plugin is my lack of directions.
I think the problem is that MAC address 1 will not match the MAC address on you MVP.
There are 2 things you can do to fix this.
If you are only using 1 MVP enter these numbers in the global tab.
Other wise add another MAC addess using the address off the MVP and enter the setting there.