2011-08-31, 01:00 AM
Trying to record only nz dvb-t on underpowered 2.6 celeron
xp sp3. playback on apacer al460. Tuner is a wand usb stick,
chip is Afateck IT9135.
Installed all software as per wiki.
On first run multiple errors occurred,kept going,set to record
total tvnz mux,at this point npvr crashed. however recording
service started and recorded successfully. All channels on mux
played back glitch free on AL460.
After reboot all errors in UI of npvr disapeared, program appeared
to be working ok. However all further recordings are unplayable.
apacer reports audio data error. picture is large blocks of color,
audio is loud pops and whistles which locks up the apacer.
Have tried multiple reinstalls with out success.
I know what I`m trying to do is achievable as first run proved.
Questions: On a straight TS record,does any processing take place,
I would have thought not.If so what minimum codecs are required?.
Do I need to write a bda capture file, if so were does it go.
Do I just copy and past to bda.inf.
Remembering none of these were present in my first succesful capture.
Thanks for any help or ideas offered.
xp sp3. playback on apacer al460. Tuner is a wand usb stick,
chip is Afateck IT9135.
Installed all software as per wiki.
On first run multiple errors occurred,kept going,set to record
total tvnz mux,at this point npvr crashed. however recording
service started and recorded successfully. All channels on mux
played back glitch free on AL460.
After reboot all errors in UI of npvr disapeared, program appeared
to be working ok. However all further recordings are unplayable.
apacer reports audio data error. picture is large blocks of color,
audio is loud pops and whistles which locks up the apacer.
Have tried multiple reinstalls with out success.
I know what I`m trying to do is achievable as first run proved.
Questions: On a straight TS record,does any processing take place,
I would have thought not.If so what minimum codecs are required?.
Do I need to write a bda capture file, if so were does it go.
Do I just copy and past to bda.inf.
Remembering none of these were present in my first succesful capture.
Thanks for any help or ideas offered.