Volume Control

[Caseyjones]

Not sure if this is the right thread but here goes.

Due to hardware problems I've just updated to WIn 7 64 Bit and NPVR.

Everything is working fine except volume. I've installed the volume plugin and mapped the right key sequence to the remote so I can change volume, but it is too sensitive.

Using either the remote or keys it changes by 15-20% for each press.

Is it possible to change the sensitivity?, ideally I'd like it too change 2-3% (then if you want a larger amount you hold the key for longer).

[steeb]

Not sure if this is the right thread but here goes.

Due to hardware problems I've just updated to WIn 7 64 Bit and NPVR.

Everything is working fine except volume. I've installed the volume plugin and mapped the right key sequence to the remote so I can change volume, but it is too sensitive.

Using either the remote or keys it changes by 15-20% for each press.

Is it possible to change the sensitivity?, ideally I'd like it too change 2-3% (then if you want a larger amount you hold the key for longer).

Hiya Caseyjones,

I suspect this is a plugin issue and therefore may be best served by moving it to the appropriate thread?

Presume you are referring to McBainUK's most excellent:

http://www.nextpvr.com/nwiki/pmwiki.php?....VolumeOSD

if so give me the nod and will move thread!

cheers

steeb

[Caseyjones]

If you could move it.

But I'm not sure whether it is a plugin issue (I'm sure the plugin just displays the current volume settting). an OS issue (as it now does volume control rather than the old GBPVR) or something else?

[steeb]

If you could move it.

But I'm not sure whether it is a plugin issue (I'm sure the plugin just displays the current volume settting). an OS issue (as it now does volume control rather than the old GBPVR) or something else?

I'm not sure if it is a plugin issue or not.

By means of this post it should bump it up the threads again. If it doesn't take any bites then I can move it over to McBainUK's OSD plugin thread.