NPVR hangs on skip if recorded file timeline is corrupt

[Bobins]

Sub,

Occasionally I get recordings where the timeline is corrupt in that when you start playback, the start position is correct and the time position shown tracks the amount of time playing but the end of recording time shows zeros.

This in itself insn't a problem...that is until the wife tries to jump forward (e.g. to skip adverts)..... at which point NPVR hangs with an windows error message and has to be killed with task manager. Whilst if you notice the end of file time is zeros, you can avoid the hang by not trying to jump, this is a pain and a frequent inconvenience (so I'm told).

Apparently me getting dragged in to use task manager is all my fault anyway for not sorting the bl**dy problem out

Is there any way Sub the error handling could be improved so it doesn't hang when the timeline is corrupt? I'd send you a sample file but they're typically >500mb.

[sub]

I'd need to see a file I could reproduce the problem with.

Is this recorded on an NTSC or FAT drive?

[Bobins]

It's on an NTFS partition. I'm not so much worried about the occasional timeline corruption as I know there can be "blips" with some satellite transmissions. If I run the file through VideoReDo quick stream fix the error is corrected.

The file plays fine in NPVR. It's just when you try to jump forward the hang occurs.

Fault bucket 50, type 5
Event Name: AppHangB1
Response: Not available
Cab Id: 0

Problem signature:
P1: NextPVR.exe
P2: 1.0.0.0
P3: 535c4ad8
P4: b0ed
P5: 0
P6:
P7:
P8:
P9:
P10:

Attached files:
C:\Users\Media\AppData\Local\Temp\WER4F36.tmp.appcompat.txt
C:\Users\Media\AppData\Local\Temp\WER4F47.tmp.WERInternalMetadata.xml

These files may be available here:
C:\Users\Media\AppData\Local\Microsoft\Windows\WER\ReportArchive\AppHang_NextPVR.exe_8268e1d5906abdbbd7b7efab3ec49e6594b4758_24b2691c

Analysis symbol:
Rechecking for solution: 0
Report Id: 3818b0c1-e0e1-11e3-b62d-001fd0aeb26c
Report Status: 0