Cannot connect to web server.

[Tech_Geek97]

I have NextPVR installed on a Dell T320 with a Ceton Infinitv 6

I have the Ceton is set up properly and everything seems to work from what I can tell.

I even checked to make sure that the web server was working by connecting to 127.0.0.1:8866 and 192.168.1.2:8866 on the web browser on the server.

A few days ago the client boxes arrived I started setting one up, ninite, XBMC, drivers, etc.

I connect XBMC to the server via SAMBA, it works fine, the same with mySQL.

But, when I try to set up NextPVR it cannot connect.

Confused I check on the server again and it still works from that browser.

When I try to connect from the client's browser I cannot connect.

All firewalls are disabled on both the server and the client.

allowremotestreaming is set to true

netstat shows the web server as being bound to 8866

Anyone have any idea what is going on here? I cannot think of any reason that this would not be able to connect.

[sub]

Sorry, there is no built in support for the Ceton devices. The only cablecard devices supported are the SiliconDust HDHR devices and Hauppauge DCR devices.

[mvallevand]

You can use the Ceton with the NetworkRecorder plugin and SageDCT, is your client also on 192.168.1. subnet and can you ping 192.168.1.2?

Martin

[Tech_Geek97]

Sorry, there is no built in support for the Ceton devices. The only cablecard devices supported are the SiliconDust HDHR devices and Hauppauge DCR devices.

I already have the ceton set up thru SageDCT it is not the problem, I have already tried disabling it to check

[mvallevand]

If the problem is on a NextPVR client unfortunately you do need to install the network recorder plugin on the client too, Any networkrecoder.xml should work.

Martin

[Tech_Geek97]

You can use the Ceton with the NetworkRecorder plugin and SageDCT, is your client also on 192.168.1. subnet and can you ping 192.168.1.2?

Martin

both are in the same subnet, I can ping. I am using XBMC as the client