HDHR/NPVR scanissues - only 2 channels instead of >145?

[ruudm]

I installed a HDHomerun Expand (DVB-C) and scanned channels with 64-QAM and 6875 symbolspeed (other info according to cableprovider Ziggo in my area: freq 474000 and network ID 4444). Many channels were found and can be viewed in Kodi 18. Then I installed NVPR for recording etc. and scanned for channels. Result: only two channels? I have disabled the firewall and scanned again, no difference. Any ideas are appreciated to get more channels. Attached is a log. Many thx in advance for your help

[ATTACHMENT NOT FOUND]
[ATTACHMENT NOT FOUND]

[sub]

Looking at the log, it appears to have correctly found everything on that frequency. There is about a dozen services on that frequency, but only three of them are TV channels. The rest are data services, which appear to be for set top box firmware updates, with service names like "Samsung 9401 L102" "Humax 5300 prod" etc. The scan results will only lists the channels.

I installed a HDHomerun Expand (DVB-C) and scanned channels with 64-QAM and 6875 symbolspeed (other info according to cableprovider Ziggo in my area: freq 474000 and network ID 4444).

474000 will only be one of many frequencies your cable provider is using. Have you scanned other frequencies, like 634MHz etc (since I can see that in your HDHR scan results)?

[ruudm]

Yes, tried to type frequencies manually and also tried to select 'all countries' + 'All frequencies 6.875) or some options in Netherlands - Ziggo. Still no luck. Is this list of any use? I can see that transportstream 19 has the channels which I found.

[sub]

Transport stream 18, is at frequency MHz, and has the 3 channels you found.

Can you try scanning 634750, then post the NextPVR.log?

[ruudm]

Log attached, scanned 634750, 6875, QAM64.

[sub]

Actually - according to the web page you provided the link to, it should be 634750, 6900, QAM256. Only 474Mhz uses 6875 QAM64, all the others use 6900, QAM256

[ruudm]

This is weird - but somehow I am a step further!

Installing NextPVR and HDHomerun setup on a clean computer (32-bits) results in a good scan of different streams. So my Kodi-system has something to do with it. That system runs on Windows 10 Pro 64-bits. Do you have any idea where to look for or what could cause this? Attached a screendump of two computers in the same network as HDHomerun.

[mvallevand]

Make sure BDA mode in the setup is set to Default and not NextPVR

Martin

[ruudm]

Found a solution!

The mistake I made (?) is that I scanned channels in HDHomerun-setup with numbers provided by Ziggo: 474000, 64 and 6875 and left those numbers in there. All channels were found inside the HDHomerun-setup even with another symbolrate and other frequencies without typing anything. NextPVR was not able to find any frequencies manually, i.e. 634750, 6900 and 265, so I got stuck.

Solution: in the HDHomerun-setup on tab 'DVB-C' change the number back to the right symbolrate 6900 (instead of leaving it on 6875). Problem solved, case closed