Hauppauge Nova-t USB2 not working

[perico]

Hi folks,

I'm trying to install and configure gb-pvr with a Hauppauge nova-t usb2 box. The installation went ok without any error message but after configuring the recording source, epg source, pressed the "update epg", as soon as I press map digital channels to epg channels, I get a popup with the following message "GB-PVR was unable to start the BDA device you have configured. Chech the device is configured properly and not already in use".
I installed the latest V. 2.0 Hauppauge drivers and also the latest GB-PVR version. WinTV works just fine.

Is there anything I am missing?
I have searched through the forum and nobody seems to have this problem.

Thanks in advance.

[sub]

Email your logs to me at support@devnz.com and I'll take a look. Include a link back to this post.

[perico]

Email your logs to me at support@devnz.com and I'll take a look. Include a link back to this post.

logs sent to support@devnz.com.

[hardrinseron]

Hi Perico,
I'm having this exact same problem with the same hardware. Did you resolve it in the end?
many thanks
Daz