Setup not fully updating?

[Tunes0710]

Hi all.
I've seen other posts about the updater keeping to 5.0.1.200103, but mine is a little different to that...

On my parents machine, I was running earlier versions of NextPVR 5 (5.0.1.200103).
From another post, it was pointed out that there was an update available, which I have run.
Upon running, I pointed it to my current installation directory (as it's in a non-standard folder) and the update appeared to go well. When I go to the webpage it now shows 5.0.1.200209

The issue is. I wanted to start using NextPVR at home as well, so did a clean install on a new machine, so both are running the latest version, but I have additional options on my settings page than I have on the install for my parents?

This is my machine
   

This is my parents
   

They are missing the transcoder button, the logout button and the paypal logo?

I even stopped and deleted the service and ran the installer again (pointing to the correct install location), but I'm not seeing those extra options.
Any ideas?

Cheers :-)

[mvallevand]

Does this help https://forums.nextpvr.com/showthread.ph...#pid534784

Martin

[Tunes0710]

Hiya,
No as mentioned, I'd seen the other threads and also carried out the stop service/delete service command and re-run the installer, but it's updated ok (which in the other threads it didn't), I just seem to be missing options from an update as opposed to a clean install.

[mvallevand]

Maybe a simple browser cache issue? Did you do a ctrl-f5?

Martin

[Tunes0710]

Well that's embarrassing....
I was sure I'd cleared the cache, especially as I used another browser as well to test it.
However, I shall make sure I double check these things in the future instead of "thinking" i'd done it.

Thanks again for your help.