2025-01-15, 09:07 PM
I have recently installed a August DVB-T210 usb stick and the recommended software NextPVR. Its a new HP Z2 G9 workstaion running windows 11.
Had a few installation issues getting webapp and NextPVR working. However I have a problem when the PC is first powered on. I get the error "Starting device: please wait" and later "streaming failed (transcode exited).
Seems the software cant start the device. I have tried turning off the security software HP Wolf Security then exited Edge browser and tried again; This sometimes solves the problem but means 20mins getting NextPVR working each time pc is turned on.
There is also a close down issue that shows as NextTV Backend says its recording and this stops shutdown. There are no scheduled recordings.
Seems like the USB stick is reluctant to start.
Have check firewall and NextPVR features and USB stick is in a USB 2 port 480Mbps.
The version of NextPVR is ver 7.0.1.241229
Any ideas?
Had a few installation issues getting webapp and NextPVR working. However I have a problem when the PC is first powered on. I get the error "Starting device: please wait" and later "streaming failed (transcode exited).
Seems the software cant start the device. I have tried turning off the security software HP Wolf Security then exited Edge browser and tried again; This sometimes solves the problem but means 20mins getting NextPVR working each time pc is turned on.
There is also a close down issue that shows as NextTV Backend says its recording and this stops shutdown. There are no scheduled recordings.
Seems like the USB stick is reluctant to start.
Have check firewall and NextPVR features and USB stick is in a USB 2 port 480Mbps.
The version of NextPVR is ver 7.0.1.241229
Any ideas?