Girder end recording event

[daza67]

Firstly I'd like to thank sub for a nice piece of software. I currently have GBPVR working quite well with Foxtel cable using a TIRA2 blaster via the girder plug-in. Due to limited outputs on STB the a/v signals are routed via my amp's record out to a prolink PlayTV@7000 capture card.

Unfortunately the amp must be switched on in order to pass through the a/v signal to record out. This is accomplished by using the sending a "on" command to the amp triggered by the GB_TUNE_EON event. I would like an event trigger at the end of recording that I could use to switch the amp off again.

Any ideas on how this could be accomplished.

Thanks
Darren

[pleemeijer]

You could use a Y adapter cable to split the signalfrom the Foxtel box to go both to the Amp and the capture card - that way, I only have to have the Foxtel box on to capture shows.

Pete