Config lost!

[nemulate]

Was messing with config and changed demuxer to SS (showshifter) and then got bsod and reboot. Now every time I try to go into config get exception error - Jet database engine stpped the process because you and another user are trying to change the same data at same time? if I select continue my config is empty beacuse i presume it cant get the config from the mdb file. Anyone any ideas? I've uninstalled showshifter to see if it helps but no luck!

[sub]

If there is a gbpvr.ldb file, you could try deleting it.

Its also possible that when you got you BSOD the database was left in an inconsistant state (in the middle of writing data or similar), leaving it effectively broken. Access databases are a bit prone to this. There probably isnt much you could do about this one.

[nemulate]

Oh well at least I'll be expert at installing GBPVR by time I finish (Not a criticism by the way just a joke I love this software to bits. This beats the commercial packages I've tried hands down! WIll donate something on payday )

[sub]

You wont need to reinstall GB-PVR. Worst case you'll just need to delete the gbpvr.mdb file.

[nemulate]

Ok all sorted not too painfull in end once added capture source again!

Thanks