2006-01-15, 10:06 PM
Hi,
I have an issue where if I record another program straight after the previous one on the same channel then GVPBR records blank for the duration of the second program.
Now I believe GBPVR happily thinks it's recording just fine because the logs indicate a normal recording ending at the correct time, however I get a 0 byte file.
I think this may be an issue with the Nova-T not handling the quick end session/begin session very well.
Is there any way to tune this or perhaps build in some kind of delay. It is a tricky area this especially with the padding time, you're bound to miss the end or the start of one of the programs... I'd rather miss a few seconds off the start than have none of it at all.
Thanks,
C.
I have an issue where if I record another program straight after the previous one on the same channel then GVPBR records blank for the duration of the second program.
Now I believe GBPVR happily thinks it's recording just fine because the logs indicate a normal recording ending at the correct time, however I get a 0 byte file.
I think this may be an issue with the Nova-T not handling the quick end session/begin session very well.
Is there any way to tune this or perhaps build in some kind of delay. It is a tricky area this especially with the padding time, you're bound to miss the end or the start of one of the programs... I'd rather miss a few seconds off the start than have none of it at all.
Thanks,
C.