More new Hauppauge drivers

[sub]

I've just uploaded http://www.gbpvr.com/drivers/Amity2_0602...elease.zip

Please note that this driver IS NOT intended for Win2000.

EXCERPT FROM THE RELEASE NOTES...

/*
** Hauppauge Release Info/History...
*/
Driver Release 2.0.43.24052.PreRelease (02/21/06)
* Improved Vista support/compliance. Filter pin medium Ids guaranteed uniquen and consistent across boots and slot changes.
* hcwPrxA2.ax version corrected (Windows thought last pre-release appeared to install an older version).
* Improved audio initialization. FM volume correct on first run if this is the first source.
* TOP settings optimized for some tuners.
* Much closer to full CCInDVD support.
* GraphEdt (for example) shows correct pin direction, medium info, etc. for all filters and pins.
* Registry Keys and Debug Output to investigate reports of Timestamps being reset.
* Single 32/64 bit INF changed into two separate INFs (according to MS requirements).

[sub]

I dont know anymore than what is posted above. I've sent them information about the timeline problem, and this build includes logic to help them determine what is going on.

[daphatty]

Looks like I will be skipping this release then. I hope they fix this issue soon. I'm holding off on installing my USB2 because I want the "fixed" drivers installed for my PVR 500 and I don't want them to break the IRREMOTE functions.

[sub]

If someone that is having this timestamp issues, and is willing to update to these drivers, and allow me to remotely connect to their machine to check things, Hauppauge have given me information on checking the diagnostic information, and registry settings to resolve the issue depending on the results.

This is your chance folks, Hauppauge are listening. Step up to the plate...

[daphatty]

If someone that is having this timestamp issues, and is willing to update to these drivers, and allow me to remotely connect to their machine to check things, Hauppauge have given me information on checking the diagnostic information, and registry settings to resolve the issue depending on the results.

This is your chance folks, Hauppauge are listening. Step up to the plate...

I will let you know if I see this problem on my PVR-500. So far, no issues.

[sub]

Thanks. I'm primarily after a PVR150 user that gets this issue often.

The sequence of events would be something like:

1) You install these updated drivers
2) You install some remote access software if you dont already have it (VNC or RemoteDesktop)
3) I remotely connect and set up a couple of things for the test, then disconnect.
4) You schedule a few short recordings
5) I connect again and take a look at the results, and put setting in place to attempt fix.
6) rinse and repeat.

[groover km]

I can do this. I have:

a) A single PVR150.
b) A logmein account that I use for remote access.
c) A history of moaning about Hauppauge drivers, so a chance to put my money where my mouth is.

Will time difference cause you any issues? Let me know if I can help.

[sub]

Cheers. PM me and we'll discuss details.

[chud]

i am also willing to step up if req'd. i have a single PVR-150 with the latest (or next to latest now i guess) drivers installed and see timeline issues on maybe every 3rd or 4rd recording. let me know if you need a second opinion...

[UncleJohnsBand]

I loaded the drivers and so far so good.....Haven't done too much recording but what I have done has been fine. I will try to get a bad timeline recording to occur over the weekend....too busy right now.

So....where is this debug output???? In the video itself? Does anyone know?