live TV pause problems

[Koenie]

Sub,

Everyting seems to be working quite well with the 96.8 version except pausing live TV. When I pause live TV it tries to use the GBPVRparser (even when set to do not use with radlight and the demuxers to prefered). When it does this i get extremely stuttering playback. Deregistering the GBPVRParser causes it to use the elecard demux, but then exits after about 2 sec and stops the recording. Deregistering the elecard demux leaves the microsoft MPEG demux but GBPVR does not want to use it for live TV (in recordings it does fine). The recording continues but the screen stays with the wait message and processor runs 100%. GBPVR at the normal 30-40% and system uses the rest.

When I unregister the elecard and microsoft demuxers it will also use the GBPVRParser for recordings and this leads to the same extrem stutter. with extreme stutter I mean that effectively the video reaches at best half the framerate, the processor usage is quite normal though.

[sub]

You run the 'Re-Register Filters' shortcut from the start menu.

You also want to have the Microsoft demulitplexer registered.

You should deregister the Elecard demux, its know to cause problems if it is present.

[sub]

Also, set your deinterlacing to 'encoder pass-through'

[Koenie]

SUB,

This is does not solve my problem. As you can see in the log GBPVR uses the Microsoft demux during the live tv, but once pause it uses the GBPVRparser again leading to stutter.