2006-01-07, 02:54 AM
Hai,
1. I've got a PVR350 and a PVR150 (retail). Everything works now, except, the remote only works over the Hauppauge IR application, and not "direct". Before I installed the PVR150 I could use the remote without the IR.exe running. Not a big problem, except I need to keep the GB-PVR window on top and active.
2. Other question, I got the IR Blaster to work with Dutch UPC Digital's "mediabox" (a Thomson box). It is codeset 505 you need to set. But, there is one little thingy: there is a different button to turn the box on than to turn it off. I want to make sure the box is turned on. The Hauppauge BlastCfg allows to send the on/off command, which for this Thomson box means "off". Quite the opposite of what I want. What commands can I send through the HaupBlast executable except {channel}?
3. Other question. I have a PVR350 with its tuner, a PVR150 with its tuner, and a cablebox (UPC Mediabox made by Thomson) on a fixed channel on the PVR350. I therefore have three sources to record from. It sometimes happens that when I program a show to be recorded over the fixed channel (UPC Mediabox), GBPVR says that a conflict is happening, even though the PVR150 source is still free. Usually the show that causes the conflict is a show that is programmed to be "repeated"ly recorded. GBPVR should assign the free source, I think.
4. Sometimes the TV Guide details for a show get updated during the week, whereby the show starts 5 minutes earlier. Now that I have two cards, I see that sometimes the show also gets recorded twice. Same show, on the same channel. Maybe GBPVR can do with a bit of intelligence that it will not record a show twice if it is overlapping on the same channel...
Thanx for looking into this.
1. I've got a PVR350 and a PVR150 (retail). Everything works now, except, the remote only works over the Hauppauge IR application, and not "direct". Before I installed the PVR150 I could use the remote without the IR.exe running. Not a big problem, except I need to keep the GB-PVR window on top and active.
2. Other question, I got the IR Blaster to work with Dutch UPC Digital's "mediabox" (a Thomson box). It is codeset 505 you need to set. But, there is one little thingy: there is a different button to turn the box on than to turn it off. I want to make sure the box is turned on. The Hauppauge BlastCfg allows to send the on/off command, which for this Thomson box means "off". Quite the opposite of what I want. What commands can I send through the HaupBlast executable except {channel}?
3. Other question. I have a PVR350 with its tuner, a PVR150 with its tuner, and a cablebox (UPC Mediabox made by Thomson) on a fixed channel on the PVR350. I therefore have three sources to record from. It sometimes happens that when I program a show to be recorded over the fixed channel (UPC Mediabox), GBPVR says that a conflict is happening, even though the PVR150 source is still free. Usually the show that causes the conflict is a show that is programmed to be "repeated"ly recorded. GBPVR should assign the free source, I think.
4. Sometimes the TV Guide details for a show get updated during the week, whereby the show starts 5 minutes earlier. Now that I have two cards, I see that sometimes the show also gets recorded twice. Same show, on the same channel. Maybe GBPVR can do with a bit of intelligence that it will not record a show twice if it is overlapping on the same channel...
Thanx for looking into this.
