2006-09-24, 04:02 AM
I have a problem with setting the channels for my Dish network receiver through the IR blaster. If I'm using just the Hauppauge remote, things work fine changing b/w channels. But if I use the Dish Network remote and GBPVR gets out of sync, then I have issues.
What I basically want to know is if there is a way to customize the output so that it will send the channel change, wait for five seconds, then send it again to make sure that it gets sent correctly. It's the first time that it gets sent that I'm missing the first digit in the number.
Thanks in advance.
What I basically want to know is if there is a way to customize the output so that it will send the channel change, wait for five seconds, then send it again to make sure that it gets sent correctly. It's the first time that it gets sent that I'm missing the first digit in the number.
Thanks in advance.