2 tuners, Device Type Check says my 150 is a 250, and a conflict!

[fldavem]

I run device type check and the log says I have a PVR 250 (though the actual appication has a blank screen). Actually, I have a Emuze Maui III and also a Hauppauge PVR 150. I have them both set to Capture Board #1 but if I try and schedule 2 recordings I get a conflict.

Any clues?

By the way, yes, the Maui III is supported and has hardware encoding.

[Ted the Penguin]

yeha when I select "only show hardware that is installed" in the capture source config it shows a 250, when I have the 150, just manually select the 150 (it is selected by default for me), see if that works

[sub]

The DeviceTypeCheck utility is only for Hauppauge cards, not cards from other manufacturers. It exists for the complicated issues that can occur when you have a mixture of previous generation hauppauge cards (PVR250/350) with current generation cards (PVR150/500).

I have them both set to Capture Board #1 but if I try and schedule 2 recordings I get a conflict.

They will both be device #1. Reproduce the conflict problem, then zip and attach the logs and I'll take a look.

[fldavem]

The DeviceTypeCheck utility is only for Hauppauge cards, not cards from other manufacturers. It exists for the complicated issues that can occur when you have a mixture of previous generation hauppauge cards (PVR250/350) with current generation cards (PVR150/500).

They will both be device #1. Reproduce the conflict problem, then zip and attach the logs and I'll take a look.

Sub: I will, thanks. Which logs do you need?

[sub]

zip and attach them all.

[fldavem]

zip and attach them all.

Sub: Thanks, I found it was user error! Both were setup as PVR150. I guess just naming it "Maui III' OK, I knew that!!!!

Dave