How to use the TV Stick (Geniatech T680) with GBPVR

[sn_redditch]

To enable support for the TV Stick (as supplied by http://www.tvstick.co.uk) - otherwise known as the Geniatech T680 - please add the following entries to 'bda.ini' :

[TV Stick]
TUNING_TYPE=DVB-T
FILTER_TUNER=Geniatech BDA Tuner (Real PEN SL)
FILTER_CAPTURE=Geniatech AVStream TS Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=BDA MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

Note : Not sure what's required to get the remote control working properly, with the settings above I can alter the volume but cannot change channels.

[sub]

Cheers, I'll include it in the master file as [Geniatech T680]. Its probably worth renaming yours so the next GB-PVR upgrade goes smoothly.

[sn_redditch]

It's always good to be able to put something back, thanks for the advice re: the next upgrade.

[jomber]

Found this post helpful. However there are two versions of the TV Stick, mine is the earlier & needs a modified bda.inf as below (both versions shown). GBPVR recognises this but I am unable to scan the channels. I shall follow this up in a separate post elsewhere (when I find the right place!). Hope this helps someone.

[Geniatech T680 Version 1]
TUNING_TYPE=DVB-T
FILTER_TUNER=USB2.0 IPBOX Geniatech (BDA)
FILTER_CAPTURE=Geniatech AVStream TS Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=BDA MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

[Geniatech T680]
TUNING_TYPE=DVB-T
FILTER_TUNER=Geniatech BDA Tuner (Real PEN SL)
FILTER_CAPTURE=Geniatech AVStream TS Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=BDA MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport