MCE Encoder and HVR-3000

[tesamu]

Hi

I finally got HVR-3000 to work in GBPVR. However the recordings are not useable. Sound is out of sync and video is skipping. I edited the graph to use MainConcept (MCE) MPEG Encoder instead of MainConcept (Hauppauge) MPEG Video Encoder and MainConcept (Hauppauge) MPEG Audio Encoder. That worked fine.

But how can I get this to work in GBPVR? Is there a way to edit direct.ini to get this working? I attach a copy of the working graph and hope someone please could take a look and hopefully find a solution.

Thanks

[sub]

Unfortunately the analog side of the HVR3000 and HVR4000 work very poorly with GB-PVR. Usually GB-PVR would only work with analog cards with hardware encoders. I did spend a few hours trying to get these devices working for analog using software encoders, but only ever got poor results, so support for them was never completed. Sorry!

[tesamu]

Hi.
Ok. I understand that, but have You tried the MCE Encoder that came with the card? I tried with Graphedit and it worked fine. It sure use a lot of CPU, but in this case the result will be fine. Is it possible to just edit direct.ini to get gbpvr to use this encoder instead?

[sub]

Is it possible to just edit direct.ini to get gbpvr to use this encoder instead?

Unfortunately you wont be able to change that with just tweaking direct.ini.

[tesamu]

Ok. Thanks anyway. I just have to wait and see if it will be supported in the future.