FM tuner not detected

[jam_zhou]

Hi, just got my PVR150 MCE...took a while but it finally worked. Now I can't get the FM tuner to work...it's saying that the FM tuner is not detected.

Here are the logs. They should show in the first one.

If it means anything, I've got an AIW which also has FM, so I was wondering if it was getting confused with it.

Also, I've noticed that with the graphrecorder plugin for my AIW and direct plugin with the PVR150MCE, I can't have the PVR150MCE as the second card when I install it. GBPVR says that I don't have the drivers installed...although it did recognize that the card was there.

Otherwise the important bits seem to be working.

Thanks,
Jam.z

[sub]

Did you check that the device type is set to PVR150MCE rather than PVR150?

Also, I've noticed that with the graphrecorder plugin for my AIW and direct plugin with the PVR150MCE, I can't have the PVR150MCE as the second card when I install it. GBPVR says that I don't have the drivers installed...although it did recognize that the card was there.

They'd both be device #1. The device number only increases if you have multiple devices using the same drivers.

[jam_zhou]

Yup, it automatically detected it as a pvr150mce

[sub]

What order do you have your capture source listed on the config app?

[jam_zhou]

I think I know what the problem is..I think the old drivers had an FM pin. The newest ones do not.

http://www.shspvr.com/graph_build/fm_mp3_recording.html

I have the PVR150 for recording and my AIW for viewing...but I also tried it without using the AIW.

Jam.z

[sub]

What order do you have your capture source listed on the config app?

[jam_zhou]

pvr150 on top and graph recorder on the bottom

[sub]

I think if they were in the opposite order it would probably work.

[jam_zhou]

hey it works...sorry for thinking I was smarter than you Now if only it would work with my original configuration...I prefer the pvr 150 to record b/c it's better quality. The AIW is a back up.

Any reason why this doesn't work?

[sub]

Its just limitation I wasnt aware of until I started looking into it for your problem.

I'll try to remove this limitation in a future release.