2007-10-12, 05:06 AM
I´m trying to setup my MCE IR-Blaster to change channels on my old Philips DSX 5500 STB. The "bug" is placed at the right place (I think) and all covered with eletric isolation tape, and it changes channels, but not always.
For example, sometimes sending the number 8 works OK but other times it doesn´t and 8 olny works again after sending another number. It happens to every number I tried to learn with HIP or GBPVR.
Someone here uses the same stb and can send me the correct codes (on HIP format or even bin/irk raw codes for using with GBPVR)?
For example, sometimes sending the number 8 works OK but other times it doesn´t and 8 olny works again after sending another number. It happens to every number I tried to learn with HIP or GBPVR.
Someone here uses the same stb and can send me the correct codes (on HIP format or even bin/irk raw codes for using with GBPVR)?