2007-12-05, 12:08 AM
I went from copper to fiber, no big deal, still an analog cable signal.
Uninstalled everything, and reinstall with the last drivers available for my PVR 250 and then installed the latest GBPVR.
Went through all the routines (my own directions kept in the Wiki), ran Tuning assistant, wrote down the channels etc, keyed them in in config.
To make a long story short, the same old routine.
So when I turn on live TV in GBPVR it shows the last channel chosen in Hauppage Wintv 2000 , although Wintv 2000 is then disengaged.When i cahnge channels in GBPVR, it goes up or down, whetever i choose, shows the differnt cahnnel names, the logo's etc. But the channel stays that same channel.
When I go to TVguide click random on a channel, I only receive noise.
Any idea what's going on????
BTW I can change channels watching live TV in Wintv 2000 very well, no prob at all.
cheers,
arttext
Uninstalled everything, and reinstall with the last drivers available for my PVR 250 and then installed the latest GBPVR.
Went through all the routines (my own directions kept in the Wiki), ran Tuning assistant, wrote down the channels etc, keyed them in in config.
To make a long story short, the same old routine.
So when I turn on live TV in GBPVR it shows the last channel chosen in Hauppage Wintv 2000 , although Wintv 2000 is then disengaged.When i cahnge channels in GBPVR, it goes up or down, whetever i choose, shows the differnt cahnnel names, the logo's etc. But the channel stays that same channel.
When I go to TVguide click random on a channel, I only receive noise.
Any idea what's going on????
BTW I can change channels watching live TV in Wintv 2000 very well, no prob at all.
cheers,
arttext
[SIZE="1"]
Abit AN-M2HD*Radeon HD 3850 HDMI out*Athlon 64X2 4400+*2x VS1GB667D2*HD-DVD Toshiba SD-H802A*Enermax EG425AX-VE*Hauppage WINTV 250*GBPVR GUI*Silverstone Lascala Case*
[/SIZE]