Confused channel changer 1.1.5

[garymeds]

hello,

fresh os and gbpvr install with newly created capture devices.

capture device 1 : hvr1300 (nova-t) BDA no channel changer
capture device 2 : pvr150 direct recording and exe channel changer

i set up the channels on capture device 1 first and have a few duplicate channels, example bbc1 which is channel #1 on capture1 and channel #101 on capture 2.

if i press 101 on the remote for BBC1, PVRX2 sends 1 to the .exe changer and doesn't tune into capture device 1 on channel 1.

is this something stupid i've done or is there a problem?
cheers

[sub]

I'm not aware of any problem with this stuff, but reproduce the problem then zip and attach the logs and I'll take a look.

[garymeds]

thanks sub - appreciate help. doesn't bother me much but wife gets confused when these things happen

is prob my setup - BBC1 for example is setup in both capture sources and also referenced twice in the Channels config tab...

attached logs

[sub]

hello,

fresh os and gbpvr install with newly created capture devices.

capture device 1 : hvr1300 (nova-t) BDA no channel changer
capture device 2 : pvr150 direct recording and exe channel changer

i set up the channels on capture device 1 first and have a few duplicate channels, example bbc1 which is channel #1 on capture1 and channel #101 on capture 2.

if i press 101 on the remote for BBC1, PVRX2 sends 1 to the .exe changer and doesn't tune into capture device 1 on channel 1.

is this something stupid i've done or is there a problem?

As far as I can tell in the logs its doing what I would have expected:

2007-12-11 16:03:20.004 VERBOSE [1] Running: C:\Program Files\devnz\gbpvr\REDEYE2.EXE -port=COM1 "=538"
...
2007-12-11 16:03:29.452 VERBOSE [1] Switching to channel: 132 (Sky Sports 1)
2007-12-11 16:03:29.453 VERBOSE [1] Running: C:\Program Files\devnz\gbpvr\REDEYE2.EXE -port=COM1 "=511"
...
2007-12-11 16:03:39.110 VERBOSE [1] Switching to channel: 26 (BBC1)
2007-12-11 16:03:39.116 VERBOSE [1] Running: C:\Program Files\devnz\gbpvr\REDEYE2.EXE -port=COM1 "=101"

Is there something wrong about this sequence of events?

[garymeds]

from the above, it looks like PVRX2 is doing what it should but doesn't seem to be getting to channel changer properly...

thanks sub

[sub]

You can see the exact command line that is being run. If redeye2.exe not succeeding to change to the correct channel, I suspect you'll need to try to resolve it on the redeye2.exe side of things rather than in GB-PVR.