Onair GT

[sjpvr]

On v1.2.13, I can't scan for channels. I get "GB-PVR was unable to start the BDA device you have configured..." I have no problems with my Hauppauge 1600 and the Onair works with the onair software. I haven't had any problems with the onair on previous releases, so maybe I'm just overlooking something. Attached are my config logs.

Thanks,
Steve

[whurlston]

Double check your bda.ini entry. It should look like:

Code:

[OnAir USB HDTV-GT (QAM)]
TUNING_TYPE=ATSC
TUNING_SPECIAL=1
FILTER_TUNER=USB HDTV-GT BDA Tuner (ATSC)
FILTER_CAPTURE=USB HDTV-GT AVStream TS Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

If that's ok, run filtercheck.exe and post the resulting log file.

[sjpvr]

dba.ini entry is correct. Couldn't see anything obvious in the filtercheck.log, so here it is.

[whurlston]

This may have to wait for sub. You may want to bump the thread when he gets back. GBPVR is reporting that it fails to find the filter but the filter exists. Other people have reported issues scanning with the new version. They solved it by downgrading to the previous version, scanning/mapping and then upgrading.

[sjpvr]

sub, any thoughts?

[sub]

What do you have the device number set to for this capture source. If it is the only OnAir GT in your machine, then it should device #1 (regardless of any other types of capture devuce in your machine)

[sjpvr]

That did it. Thanks!