Channel scanning, preview shows but no channels found

[shiftlocked]

Hi All.

Ok setup my compro E700
Tested with compro software for signal, works all ok

Now into GBPvr
Setup the signal and card all ok and the correct transmitter
Do a scan and the little preview box shows up a few channels,
Signal strength is 100% and comes through nicely.

however at the end of the scan I get the error about No Channels found Pleas check your signal and configuration settings.

Running this on Vista Home Premium edition.

Can anyone help please? I have scanned the forums to no avail so far.

[sub]

Try running ReRegisterFilters.bat, then do another scan. If it still doesnt find any channels then zip and attach your config.exe.log and config.exe-native.log and I'll take a look.

[shiftlocked]

Hi Sub,

Thank you muchly, that worked a treat. I now have an issue with the DVB guide not doing anything when doing an update. Ill have a poke around the forums to see what there is about it, if you do have an idea tho would be muchly appreciated.

Thank you once again.

[nemulate]

Have you got a c:\temp folder? Have a look in config to see where the recordings folder is pointing to.

[shiftlocked]

OOO well looky at that, it worked :d Job done on that and many thanks once again!