2008-07-21, 02:38 AM
I have a strange problem, i am hoping someone can point me in the right direction.
I have GBPVR setup using a MCE Remote and Blaster. V2 1390 i think it is.
I can get the blaster working fine using GBPVR builtin function or Hip or IT Suite, configures and tests AOK. THen when i use it, the chanels change once, then start skipping numbers the second try, then stops working.
If i remove all configuration and reboot a few times i can do it again, but again after 1 successful change it fails again.. any ideas? Can you point me in the right direction?
Thanks,
JQE
I have GBPVR setup using a MCE Remote and Blaster. V2 1390 i think it is.
I can get the blaster working fine using GBPVR builtin function or Hip or IT Suite, configures and tests AOK. THen when i use it, the chanels change once, then start skipping numbers the second try, then stops working.
If i remove all configuration and reboot a few times i can do it again, but again after 1 successful change it fails again.. any ideas? Can you point me in the right direction?
Thanks,
JQE