Live tv not returning from pause on 1.3.11

[Tonka]

Here is my original post from the announcement thread:

I must have done something wrong but I installed 1.3.11 over the .7 and then paused live tv would not start back. I dont think it was creating the temp file. I removed it completly and went back to .7 and it is working again. I will try again tomorrow after a uninstall and put .11 and see if just messed up the first time.

I have uninstalled the .7 and installed the .11 and the problem still exists. Live tv not resume from pause. I can see the HDD writing the data.

[sub]

Reproduce the problem, then zip and attach the logs and I'll take a look.

[Tonka]

OK. Sorry for the delay. here are the logs. I started Live TV did pause waited a bit and then tried to start back but the screen stays black. When I put .7 back it works as it should.

[sub]

You currently have the video decoder set to 'MPEG Video Decoder'. What other options do you have available, and have you tried them?

[Tonka]

I have the cberlink ffdshow and MPV. I have tried them and normally have it on MPV but forgot to put it back on PMV

[sub]

Can you pause it using the MPV decoder, then post those logs agin.

[brettdm12]

I have had the same problem with 1.3.11. I was learning how to use the on screen controls and I hit the pause button. The video thereafter went blank. I have been using all of the default settings. My next step would be to reinstall. Any help?

[sub]

Reproduce the problem, then zip and attach the logs and I'll take a look.

[brettdm12]

Just to clarify. I have gotten the EPG working using XMLTV and setup the channels. All were working fine. I have tried to unpause, change configuration settings, restarted the service, rebooted the machine. None of these things fixed the no video problem. I tried the tuningassistance and it reckonized the analog channels through my cable.

[sub]

As I said above, reproduce the problem, then zip and attach the logs and I'll take a look.