Great audio, no picture

[ConXtionS]

Hi

I have just installed GBPVR....

I had to install another video card to get rid of the VMR9 error...

No, when I go to watch live tv I have great sound, but the screen is black... no picture what so ever...

what do I need to tweak???

thanks guys

Jim

[Graham]

Did you select decoders from the drop down lists for Video Decoder and Audio Decoder on the Playback tab of Config. Leaving these on system default is not recommended.

[Jaggy]

As you said it was a clean Windows install you may not have any codecs installed, if you check out this wiki page there are a couple of links to commonly used codecs on it

http://gbpvr.com/pmwiki/pmwiki.php/Config/Playback

[ConXtionS]

Thank you for the fast reply... going to read that now...

And no sir. I dont think I have changed anything other than what the ANALOG setup instructions said to do....

I admit.. the sound is good... better than nothing

[ConXtionS]

Ok... when I go to the playback page

Under MPEG2 Playback

Video Decoder says system default and I have no other choices.

I have downloaded the mpeg2dec and the mpadecfilter files and extracted them... But I am clueless as to how to install them

thanks again

[ConXtionS]

Sorry... I went back and READ the instructions

I had to add the Mpeg2DecFilter.ax through the run command just as the instructions said to do.

I now have picture and sound... so at least for the moment I am all hooked up

thank you very much for the help

Jim