Hauppauge Remote Hardware

[DeanNZ]

Hi

I have a pvr-150 with the beanbag. The blaster is plugged into the beanbag (port 1 but same with port 2) which in turn is plugged into a USB port. The remote and bean bag work fine.

When I try to run the ir blaster configuration wizard I get hardware not found.
In desperation I installed the entire Hauppuage CD which also made no difference.

Under device manager (USB) I can see
eHome infrared receiver

Is there anything else that shoul be listed here?

Thanks
Dean

[pBS]

that's a mce type receiver.. you can set config remote type to mce type and it should work ok...[as long as it shows driver installed in device manager]

if you'd like to customize the buttons without adding software, see this link..
http://forums.nextpvr.com/showthread.php?t=43135