Hauppage HVR-950 video

[kc5zfz]

I'm new to GBPVR. I followed the installation and config guides (http://forums.gbpvr.com//showthread.php?...-available). As it was scanning the OTA frequencies (it did a good job finding everything), I could only hear audio from each channel, there was no video, just black. Same thing when it finished the scan, no video when I clicked on a channel to preview. I know the video on this hardware works, because I have been using WinTV2000 for quite a while. I completed the setup and opened PVRX2 and it was the same as the previews, very good audio and correct channels, but no video, just black. If I close PVRX2 and open WinTV2000, I get video on all channels, so it's not a weak signal issue

Any suggestions on what I did wrong and what I can do to get it working with this software?

[sub]

What MPEG2 video decoder do you have selected?

[kc5zfz]

System default,

I'll try some of the others to see if that does the trick.

[sub]

Yep, do that.

[kc5zfz]

cool, the ATI decoder works, I thought that was the system default, but no matter, thanks!