Hauppauge IR Blaster
|
2012-05-10, 01:45 AM
I have PVR-150 with the hauppauge IR blaster. When I run GBPVR, everything works fine (so wiring etc are good). However, when I try to run NPVR, it does not work. I have it pointed to the hauppblast.exe (tried both the one in the npvr directory and the one in the GBPVR directory.)
2012-05-10, 01:53 AM
Was the executable set prior to importing the channels, or did you change it after?
Its probably worth reproducing the problem, then post the npvr.log/nrecord.log files.
2012-05-10, 10:25 PM
I set the executable and (without saving and coming back) set the import channels; then saved.
I am not sure how to "reproduce". I run GBPVR and it works so I know everything is working. I close GBPVR then run NPVR, and no response to blaster.
2012-05-10, 11:07 PM
chemie Wrote:I am not sure how to "reproduce".Just start npvr and try watching a live tv channel or doing a recording.
2012-05-11, 11:16 AM
OK. Will do and post log lfiles tonight. Thanks
Also, would it be better to set executable and try without channels imported? Or was your earlier post impliying it better to have imported too?
2012-05-13, 03:26 AM
Quote:2012-05-12 16:55:43.916 [INFO][6] AnalogRecorder.StartStream(LIVE&C:\Program Files\NPVR\Temp\live-300 CBHT-3109.ts)As far as I can tell, NextPVR is running the specified blaster. Does the command line work fine when you running it manually? ie, from a command prompt: "C:\Program Files\NPVR\HaupBlast.exe" 300
2012-05-20, 05:10 PM
Yes, running the command prompt does change the channels. I also noticed that the channel up and channel down on the remote work. However, no other commands/buttons work. Typing "300" in the NPVR gives nothing but this immediately worked inside GBPVR.
I am wondering if this has something to do with irremote.ini in c:\windows ?
2012-05-20, 05:34 PM
chemie Wrote:I am wondering if this has something to do with irremote.ini in c:\windows ?Yes, you need to put something in irremote.ini. See http://www.nextpvr.com/nwiki/pmwiki.php?...ttonRemote |
|
|
