PCH Skip/Rewind Buttons Not Working Durring Playback

[Tony]

Hello All,

I recently had to replace a non functioning main board and re-install win xp. I have been using GBPVR (since I read NPVR would have problems with xp) and re-installed it over my backup of the devnz\GBPVR directory in program files.

Almost everything works just as before (all of my recordings are found, and play, tv channels, plugins, pch opens GBPVR, etc.) but most of the buttons on the pch a-100 remote are no longer recognized during playback.

Most importantly the skipping forward or backward during playback. Strangely enough these very same buttons work just fine when being used to navigate within the GBPVR interface, they just stop working once playback starts.

I've searched the forum and wiki and tried everything I can think of.

Any help would be greatly appreciated.

Thanks in advance.

[mvallevand]

I don't support gb-pvr anymore but even if I did you have 3 servers running so the logs aren't correct the only thing I saw was logs tht looked to be for an mvp.

Maybe you don't have a config.xml entry with PCH2 mode enabled?

Martin

[Tony]

Thanks for your response Martin.

Do you mean this config entry "<MVPClientType>PCH2</MVPClientType>"?

I changed the number of servers to 1, exited the config and restarted the pch, attempted to fast forward and attached the logs.

Sorry I'm so far behind. Do you recommend I upgrade to NPVR in spite of the potential problems with xp?

Thanks again for helping with this.

[mvallevand]

Yes you would you need a PCH2 entry for 0006DC80C29F

I have always been torn about upgrading since gbpvr was so good, and other than wanting to support sub, I'd probably still be using it. However I am not sure about xp specific issues, gb-pvr has some too.

Martin

[Tony]

That did it Martin!

Your the greatest!!!

The other buttons (like the red,green, yellow, and blue) are now working also.

Thank you so much for your help!