Hauppauge DCR-2650 not detected by system

[hummvee2134]

Hey folks,

I recently installed NPVR however my DCR-2650 cable-card tuner isn't showing up in the list of devices. I've read about other NPVR systems that are working fine with this tuner so i must be missing something simple here.

I'm currently using the device with windows media center and it's working well (drivers installed properly etc.). I've also made sure media center isn't using the tuner at the same time npvr is attempting to detect it.

I've gone through the pre-requsite checklist to make sure everything is installed on the system. I've also gone through the softpvr/wintv7 installation (no cd workaround) in the knowledge base. I know this is a digital tuner but i was just trying stuff.

I've tried to due my due diligence and have a good Google search and search through the forums but wasn't able to find much else than the above. i appoloize in advance if i missed anything and greatly appreicate any help you guys can provide.

I've attached a set of logs to the thread. the very last thing i did before pulling the logs was open the devices page.

Thanks in advance.
-Jake

[sub]

You probably need to install the Windows download from http://www.silicondust.com/support/hdhomerun/downloads/

This Hauppauge device is actually a SiliconDust device, and NextPVR depends on components from the SiliconDust software. Earlier versions of the Hauppauge software installed these components too, but they removed it in later versions. You can still just run the SiliconDust installer to get it working though.

[hummvee2134]

Thanks for the response. I went through the installation successfully and after installing, the app through an error saying 0 tuners found.

I went back to NextPVR though and the card showed up just fine in devices so it looks like i'm good to go for now. Thanks for your help and quick response!