PCH not working after IP address change

[marc]

Hi,
I have had a PCH working successfully for some time now, but having got a new router I was forced to change the ip address range I was using. Since then I have failed to get the PCH working again. I have changed the address in the settings on the box. The box gets as far as the press enter to stop loading NPVR screen but never loads.

Am I right in thinking that to get this screen means that the PCH is communicating with the media server correctly, if so I don't understand why it now does not load NPVR. Is there another reference to the old ip addresses somewhere I have forgotten that needs changing.

Must be something obvious it is only a couple of ip addresses that changed,

Thanks for any help

[HarryH3]

Perhaps your PCH has the IP address hard coded in it, so it is searching for the server at the old address? Check out step 2 of the wiki here: http://www.nextpvr.com/nwiki/pmwiki.php?...lingmvpmc2 That may help you get it sorted.

[mvallevand]

You likely need to redo the mvpmc share and edit the IP in npvr.cgi If that doesn't work it's best to start with running the NMT Syntax check.

Martin

[marc]

Thanks guys, what I had missed was the IP address held in npvr.cgi , updated that and away it went!