EPG screen black....???

[AZ_Ron]

Hey guys... I setup my HT using GBPVR and Cox digital cable and Zap2It... EPG worked fine, recorded several shows, no issues at all... We switch to DirecTv, and I went to Zaps page and changed my settings from Cox to DTV, then fired up GBPVR and went to update EPG...nothing changed...still had the cox channels... so I deleted that setup, then setup a new capture source, using Zap2it, saved it, then went in and updated it... all I get is a black screen where the channels should be... I've tried several times, but can't seem to figure this one out.... any one have any suggestions??
BTW, I'm using Version 0.21.4

Should I upgrade GB?

Thanks!!!

I'm still searching the forums to see if anyone else has had this issue...

R

[sub]

Yes, you would have needed to delete and recreate the capture source to get rid of the old channel line-up. I'm guessing you've just set something up wrong on the new capture source. Right card type, device number, and input?

[AZ_Ron]

Actually, the black box is in the config area... where it used to show my cox channels, and which ones were checked and which ones weren't... It's all black, except for a couple of white 'spaces' in the upper left hand corner of that box...
When I got to run the software and go to the channel guide, it shows the correct date and times on the top bar, but there's nothing else there except a window that says 'No guide information is available'

I'm a bit stumped... I'm going to go ahead and unstall the version I have, and install the newest version and try everything fresh... Any other ideas?
If this works, I'll post back...

Thanks Sub!! I loved GB when I had Cox... no probs at all... I think this is just a glitch...

Ron

[sub]

Did you do an 'Update EPG' after adding the capture source and configuring you zap2it username/password?

[AZ_Ron]

Yes... I tried everything I could think of...Still didn't work...
I just uninstalled the older version, downloaded and installed the newest version, and bam.... it works now... I'm figuring it was a glitch with
changing guides... ie. From Cox to DTV...

Woo hoo.... off to play I go...

Thanks Sub!! COOL Software!

R