2021-09-21, 04:00 PM
I've been trying to get the Plato TV extra working on my test system but I've run into a issue and I can't get a stream started. I believe I have everything correct but apparently not. The channels show up correctly within NPVR when trying to start a stream it errors out with "streaming failed (transcoder exited)".
The test system is a headless clean Ubuntu 20.04 server VM install with 4 cores and 8gb of ram. The only items installed other than the base install is NextPVR, Streamlink, python3 and the various Streamlink required mondles. NPVR has nothing setup but the PlatoTV extra. The log attached is clean, the system was rebooted, "channels" clicked in the web interface and a channel selected. Once the stream failed I grabbed the log.
Any advice would be welcome
The test system is a headless clean Ubuntu 20.04 server VM install with 4 cores and 8gb of ram. The only items installed other than the base install is NextPVR, Streamlink, python3 and the various Streamlink required mondles. NPVR has nothing setup but the PlatoTV extra. The log attached is clean, the system was rebooted, "channels" clicked in the web interface and a channel selected. Once the stream failed I grabbed the log.
Any advice would be welcome
NextPVR V6.1.5.231022 - Ubuntu 22.04 VM / 4 core / 8Gb memory
HDHR Prime X2 / HDFX-2 /Schedule Direct / 2X Pi4 + & 3X Pi3 LibreELEC Kodi clients
Server - TrueNAS/ SuperMicro MBD-X10SL7-F MB / Xeon E3-1246 / 32Gb Unbuffered ECC / 8 X 4TB RAIDZ2
HDHR Prime X2 / HDFX-2 /Schedule Direct / 2X Pi4 + & 3X Pi3 LibreELEC Kodi clients
Server - TrueNAS/ SuperMicro MBD-X10SL7-F MB / Xeon E3-1246 / 32Gb Unbuffered ECC / 8 X 4TB RAIDZ2
