Hauppauge IR Blaster Plugin problem

[sergr]

Hi!

I have a PVR-150 card with ir blaster.
I can record programs with Hauppauge scheduler.

When I try to record with gb-pvr I get the following message:
"Failed to load resources from resource file
Please check your Setup"

I get this message when I restart the recording service and have selected "Hauppauge IR Blaster Plug-in"!

I have checked 2 log files but I can't find anything useful in them:
GBPVRRecordingService.exe.log
GBPVRRecordingService.exe-native.log

If I select "No channel changer required" I can restart the recording service and record programs but gb-pvr doesn't change channel!

I am very pleased with the gp-pvr in general!
Works perfect for my needs of a pvr!
Thanks for a great app!

Best regards,
Greger Sernemar
Stockholm
Sweden

[sub]

hmm, that doesnt really make sense since it doesnt actually try to do anything with the Hauppauge IR Blaster until it need to change channels. Sorry, I dont know.

[sergr]

I had a recording pending.
When I have no recordings pending I can restart the recording servce without problems.
But when a recording starts I get the error message.
/Greger

[sub]

Configure your capture source to use the .exe channel changer, and point it at c:\program files\devnz\gbpvr\haupblast.exe

[sergr]

I tested it with mixed results.
I can record without errors but the channel in my box won't change!

[sergr]

My hauppauge is installed in C:\Program and NOT in C:\Program Files\
if thats any help.

[sub]

You should be using the ".exe channel changer" method, as that replaces the builtin plugin, which had problems from being used in two processes.

I tested it with mixed results.
I can record without errors but the channel in my box won't change!

Yeah, I'm guessing its just moved your problem from one executable to another. Either way it sounds like the Hauppauge IR Blaster isnt in a fully functioning state given both of these unrelated methods have problems.

[sergr]

You should be using the ".exe channel changer" method, as that replaces the builtin plugin, which had problems from being used in two processes.

I am using the ".exe channel changer" method.

Yeah, I'm guessing its just moved your problem from one executable to another. Either way it sounds like the Hauppauge IR Blaster isnt in a fully functioning state given both of these unrelated methods have problems.

So what shall I do????

[sub]

I dont know. Maybe try reinstalling the Hauppauge drivers, or a different version.