GB-PVR and USB-UIRT don't work for me.

[blader_se]

I can't see how to get USB-UIRT to work for me.

I have two SAT-Recievers, sending to my PC on two channels (A and B) through an antenna wire. I currently use the SAT remote to manually change channels, (while the card still tunes only A or B). EPG works fine with this setup.

Now, I want to use my USB-UIRT but can't figure out how to set it up.

In the config, when setting up channels, I have specified channel A or B for all channels (ie the channel that the PVR-250 should tune in). It seems that this channel number also specifies what is sent by the USB-UIRT, but I think I need to specify that seperatly?!

Any help appreciated.

[sub]

Set all the channel numbers to what the USB-UIRT should send to the SAT-Reciever.

In the Direct Recording Source setup, configure it to use the 'Fixed Channel, external tuner' option, and set the constant channel number to whatever channel the signal will be recieved on.

[blader_se]

Thanks sub, you are the best!

I assume I'll just need to add a seperate capture source for my second SAT box...

Cheers