BDA.ini entry for Hauppauge Nova-T500 Dual Tuner

[Babnik]

After a little trial and error, and perhaps a little luck, here are the entries needed for this card :

[Hauppauge Nova-DT #1 DVB-T]
TUNING_TYPE=DVB-T
FILTER_TUNER="Nova-DT DVB-T Tuner (Dev1 Path0) "
FILTER_CAPTURE="Nova-DT DVB-T Capture (Dev1 Path0) "
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

[Hauppauge Nova-DT #2 DVB-T]
TUNING_TYPE=DVB-T
FILTER_TUNER="Nova-DT DVB-T Tuner(Dev1 Path1) "
FILTER_CAPTURE="Nova-DT DVB-T Capture(Dev1 Path1) "
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport


Note the quotation marks and the space at the end.

[sub]

Cheers

[Babnik]

Slight change to the second tuner

[Hauppauge Nova-DT #2 DVB-T]
TUNING_TYPE=DVB-T
FILTER_TUNER="Nova-DT DVB-T Tuner (Dev1 Path1) "
FILTER_CAPTURE="Nova-DT DVB-T Capture (Dev1 Path1) "
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

[sub]

Cheers again.

[brichards]

How do you do that please on Nova T 500

Brian

[sub]

These entries above should already be in your bda.ini file these days.

When you setup you capture source, use the BDA Recording Plugin, and tick the 'only show devices detected in this machine' checkbox and it should find your device.