Setting up Twinhan 102g with new release

[sub]

FWIW, I had a few minutes and tried your above posted config file. For me, it got rid of the Twinhan ghosts and all channels scan in fine for me on 110 and 119.

Great.

I still have a handfull of unknowns, but that was typical when I was playing with this before.

If you'd like this resolved, I'd need a 50MB or so full transport stream recording so I can run it through the debugger here. Let me know.

[CFC]

You could try the attached patch. You'd also need to add the 'ONLY_SCAN_ON_LOCK=1' line on the card you've got selected in the bda.ini.

Should I add this to my bda.ini file?
I do get this symptom while scanning where it repeats the channels from a previous transponder.
I'm using a Twinhan 1020A on 1.2.9.
Will the current config.exe accept the 'ONLY_SCAN_ON_LOCK' option, or do I need this patched one?
(I'm not currently at home, so I can't check my bda.ini file to see if the option is in there already).
Thanks for the help,
CFC

[sub]

Should I add this to my bda.ini file?
I do get this symptom while scanning where it repeats the channels from a previous transponder.
I'm using a Twinhan 1020A on 1.2.9.

You could try.

Will the current config.exe accept the 'ONLY_SCAN_ON_LOCK' option, or do I need this patched one?

The current config.exe should be fine. No patch required.

[CFC]

You could try.

The current config.exe should be fine. No patch required.

That seems to have done the trick thanks.

Now I have an issue with not being able to tune to channels with multiple SID's.
Is this a Twinhan related problem as well.
I posted a question about it here: http://forums.nextpvr.com/showthread.php?t=35068

Thanks again for the help.
CFC