How to connect Dish Net 211 to Hauppauge 1600

[dc9mm]

Just got Dish Network installed. Was useing just an antenna before. Had coax cable from antenna going into the ATSC/clear QAM digital cable input on the Hauppauge 1600 cards.I have two 1600 cards.
The dish Network STB is the HD 211 box. It has coax composite component and hdmi outputs.I was hoping to record HD programming from the STB to PC. How should i connect the Dish 211 STB to the Hauppauge 1600 card??
I ask because it says in the 211 manual that coax and S video and composite are for SD TV. Not sure if thats just a recommendation or that only SD comes out of those connections only.

[dc9mm]

forgot to put my connections on my hauppauge card looks like this

[sub]

Sorry, you're not going to be able to record any highdef from a STB with this card. Best you can probably do is svideo, for capturing standard definition.

If you a Hauppauge HD-PVR, then you could capture high def component output from the STB.

[dc9mm]

Ok thats what i thought but i wanted to make sure. Now i hope setting up the IR blaster so my 1600 card can switch the channels on the STB wont be to hard to figure out.

Any hints there? It looks like there is a IRblaster software that came with my hauppauge 1600 card but it never installed. I guess because it didnt detect the ir blaster since i didnt have it connected before since i didnt need it before. Going to try to connect the irblaster transmitter and run the software when i get time this week. Iam hoping its straight forward.