Re-order capture sources without loosing existing

[bgowland]

I currently have two capture sources - top down on the Capture Source page, PVR350 (#2) and Nova-t (#1).

I now want to put my PVR500 in but want the tuners to be capture sources #4 and #3 with the PVR 350 still as #2 and Nova-t as #1.

The only way I can see of doing this is to delete the existing setup then add the 500, 350 and Nova-t in that order. If I do that, however, I'll loose my Ready recordings.

Any way around this? (A hack of the GBPVR.MDB for instance?).

Brian

[sub]

Not easily unfortunately. You'd need to change the capture source oid's in MSAccess, but they're referenced in lots of places...

[bgowland]

What I figured - I've just been looking at it.

One thing that occurred to me is that the 350 has oid 19 and the Nova-t has oid 20. If I renumbered the Nova to be oid 22 and found the references for that (there are less than the 350) and then put the 500's tuners in as 20 & 21 then it wouldn't be so bad.

Or isn't it as simple as that?

[bgowland]

Quote[/b] (bgowland @ Feb. 02 2005,23:50)]If I renumbered the Nova to be oid 22 and found the references for that (there are less than the 350) and then put the 500's tuners in as 20 & 21 then it wouldn't be so bad.

No - that's not what I meant. What if I put the 500 in as oid 17 & 18.

In other words, is the lowest oid the highest capture source number?

Brian

[sub]

Quote[/b] ]In other words, is the lowest oid the highest capture source number?

Yes.

[bgowland]

Thanks - I'll think about it when I'm asleep and maybe try it later.