Gbpvr + stb dch70

[Tamakh]

I'm sure this is documented... but I'm not finding it.

I have a 1600 that is connect with an IR blaster to the STB DCH70. I'm able to change channels on the STB using HaupBlaxt.exe.

Here is the quesiton... I'm only able to watch channel 3, when I use the TV Guide to watch anything else it goes to static. I'm guessing its not tunning channel 3 anymore from the STB so its not working.

How do I fix so I can record and watch live tv?


Thanks for the help!

[Graham]

Did you find these ...

http://gbpvr.com/pmwiki/pmwiki.php/Confi...nelChanger
http://gbpvr.com/pmwiki/pmwiki.php/Hardw...nelChanger

[Tamakh]

Yes i'm able to change channels but I'm trying to figure out how to not change the TV Guide channel.

I found this: http://gbpvr.com/pmwiki/pmwiki.php/Manual/SetupSTB

But when I go to Digital Recording Plugin my screen looks nothing like the wiki. I dont have "Source" or "Constant Channel" listed.

Is the wiki off or am I not doing it right?

[Graham]

Is the wiki off or am I not doing it right?

I suspect that you're not doing it right. Is the STB connected to the tuner card using composite or svideo? If yes, then it is an analog source (even though the broadcast received by the STB is digital).

This link might be a bit old but hopefully you will get the idea ...

http://gbpvr.com/pmwiki/pmwiki.php/Config/DefineSource

[sub]

But when I go to Digital Recording Plugin my screen looks nothing like the wiki. I dont have "Source" or "Constant Channel" listed.

Is the wiki off or am I not doing it right?

That setting is in the "Analog Recording Plugin", not the Digital recording plugin.

[Tamakh]

That setting is in the "Analog Recording Plugin", not the Digital recording plugin.

That was it. The wiki could be a little old. Thanks all for the help! I can now record my UFC/WEC again!