Initial Setup, "No channels found"

[tstack77]

I have been pulling my hair out for the last hour trying to figure out how to get my channels recognized. I got my correct EPG list from SchedulesDirect and have followed whurlston's guide to this roadblock. I'm running on Win7 x64 with an Avermedia Duet A188 tuner.

Attached:
config.exe.log
config.exe-native.log

[whurlston]

Are you trying to tune cable or over the air?

[tstack77]

I have comcast and am trying to tune just the basic clearQAM channels. If you read in the logs that I tried tuning standard OTA signals as well, I did...I tried everything :o

[whurlston]

The bda.ini entry sub gave you is for OTA. for QAM, try this entry:

Code:

[AverMedia Duet A188 (type2) [color=Red][B](QAM)[/B][/color]]
TUNING_TYPE=ATSC
[color=red][B]TUNING_SPECIAL=2[/B][/color]
FILTER_TUNER=AVerMedia 716x BDA ATSC DC Tuner
FILTER_CAPTURE=AVerMedia 716x BDA Digital Capture
PIN_TUNER_IN=Input0
PIN_TUNER_OUT=MPEG2 Transport
PIN_CAPTURE_IN=MPEG2 Transport
PIN_CAPTURE_OUT=MPEG2 Transport

Then just make sure you have the "(type 2) (QAM)" selected as your device.

[tstack77]

That worked perfectly, thank you!