Hauppauge 45 buttons remote responses slowly in nPVR

[xavi]

First of all I want to thank all GBPVR and NextPVR collaborators and developers, last two years I have been using GBPVR daily.
The second I want to apologize my bad english.
I read same posts about the same problem, but there is not a solution, or I am not able to find it.
I have a Hauppauge Wintv-novat-500 with a Hauppauge 45 buttons remote. It has been working fine in GBPVR.
I am installing, with the same hardware, nPVR and the remote responses very slowly. The first key pressed is executed inmediatly, but the second, third... are executed with 3 o 4 seconds delay.
I modified increasing and decreasing the repeatdelay parameter in iremote.ini, but it has any effect.

One more thing, for every key pressed there are two movements executed, that is, I press only one time the down button in the menu and the cursor moves only once inmediatly down, and after 3 seconds moves another time without pressing any key.

Thaks.

[wodger]

Sub and a few others helped me get to the bottom of this (well, they did all the work while I spent time with my family :o )

This was the thread:
http://forums.nextpvr.com/showthread.php...quot-issue

Basically you need to tidy up the [NPVR] section of the c:\windows\irremote.ini file. Remove any comments and spaces at the end of each command. If you use comments, put them on a line of their own. When the spaces and comments are in the same line as the actual command, the remote is sending them as well, causing the delay. The example irremote.ini file in the wiki will currently cause this problem, so if you used it, you need to clean up the file for sure. I did that, and restarted the IR software and fixed it straight away. Good luck!