suggestion: show status of "update EPG"

[janoonk]

Suggestion:
When I update my EPG this will generally take some time which is fine because you can also close the window so no problem.
But you never know when it's finished, so after a few minutes you press the button again. If it's still running you can see the status BUT when it was finished it will start all over again.
Would be nice if you could somehow see when it's finished so you won't accidentally run it again when you just want to check the progress.

[sub]

I'm implemented this for the next build. The status is shown below the 'Update EPG' button.

[janoonk]

I'm implemented this for the next build. The status is shown below the 'Update EPG' button.

thanks