Hauppauge PVR USB & Hibernate

[hasso]

I am considering adding the PVR USB version to my system which presently has the PVR350. Thanks to the forum I can now successfully wakeup the PVR350 when coming out of hibernate.

How about the USB version? Anyone out there know if I will experience any issues using this device when coming out of hibernate?

[herbs]

I have the pvr usb2 and it wakes fine from hibernate mode. I did have to turn off "Allow the computer to turn off this device to save power" in the usb hub section under device manager though as sometimes the tuner wouldn't tune properly (the picture would roll and colours were off in about 1 in 20 hibernates). Since then it has been working a 100%, the only other issue is that if you turn the pc on without the pvr usb2 plugged in, it sometimes doesn't initallize and you get a yellow triangle in device manager. But this is a problem at hauppauges end not gbpvrs, I over come this issue by leaving the pvr usb2 plugged in all the time. I have also been told other people have overcome this issue by using a 4-6 way power cord and switching this off so the power is cut to the pc and pvr usb2 at the same time, and when its turned on both come on at the same time.