2006-12-11, 06:19 PM
Hi
I have un-installed the software and re-installed it, then did to procedure you described again. Now it at least doesn't show the error message when clicking config.
Now I have the problem of nt being able to get it to recognise the freecom. I have set the recording source as follows :-
recording source = BDA recording plug-in
device type = freecom dvb
epg source = bleb(uk)
I have tried to tune the channels in by clicking on "map digital channels to epg channels" but i get the following error "failed to locate configured BDA capture device" and "unhandled exception error" as follows :-
See the end of this message for details on invoking
just-in-time (JIT) debugging instead of this dialog box.
************** Exception Text **************
System.NullReferenceException: Object reference not set to an instance of an object.
at NativeUtilities.BDARecorder.SubmitTuningRequest(String tuningRequest, Boolean force)
at NativeUtilities.BDARecorder.StartScanTransponder(String transponder, Int32& signalStrength, Int32& signalQuality)
at Config.Plugins.x501d1ffea8b79320.x692a1118e1794d77(Object xdf2e3583f942db7b, EventArgs xc4f45905cb1fc7ba)
at System.Windows.Forms.Timer.OnTick(EventArgs e)
at System.Windows.Forms.Timer.TimerNativeWindow.WndProc(Message& m)
at System.Windows.Forms.NativeWindow.Callback(IntPtr hWnd, Int32 msg, IntPtr wparam, IntPtr lparam)
I have tried freecom dvb 2 but no difference. Is it something about the way the drivers are installed as there is no way to install them manually. You have to install the whole freecom software to install the drivers. Have I done this wrong ?
Thanks
I have un-installed the software and re-installed it, then did to procedure you described again. Now it at least doesn't show the error message when clicking config.
Now I have the problem of nt being able to get it to recognise the freecom. I have set the recording source as follows :-
recording source = BDA recording plug-in
device type = freecom dvb
epg source = bleb(uk)
I have tried to tune the channels in by clicking on "map digital channels to epg channels" but i get the following error "failed to locate configured BDA capture device" and "unhandled exception error" as follows :-
See the end of this message for details on invoking
just-in-time (JIT) debugging instead of this dialog box.
************** Exception Text **************
System.NullReferenceException: Object reference not set to an instance of an object.
at NativeUtilities.BDARecorder.SubmitTuningRequest(String tuningRequest, Boolean force)
at NativeUtilities.BDARecorder.StartScanTransponder(String transponder, Int32& signalStrength, Int32& signalQuality)
at Config.Plugins.x501d1ffea8b79320.x692a1118e1794d77(Object xdf2e3583f942db7b, EventArgs xc4f45905cb1fc7ba)
at System.Windows.Forms.Timer.OnTick(EventArgs e)
at System.Windows.Forms.Timer.TimerNativeWindow.WndProc(Message& m)
at System.Windows.Forms.NativeWindow.Callback(IntPtr hWnd, Int32 msg, IntPtr wparam, IntPtr lparam)
I have tried freecom dvb 2 but no difference. Is it something about the way the drivers are installed as there is no way to install them manually. You have to install the whole freecom software to install the drivers. Have I done this wrong ?
Thanks